Audi A3 Recalls
Safety recalls covering the Audi A3 in DVSA's recalls data, newest first.
Last updated 22 November 2026
Short answer:
DVSA's recalls data lists 24 safety recalls covering the Audi A3, the most recent dated 8 August 2025. A recall only applies to vehicles built within set dates or VIN ranges, so check the registration with our free reg lookup to see whether a car has an outstanding recall, then confirm on GOV.UK.
Check a registration for outstanding recalls, free
Every Audi A3 recall
Open a recall to see the fault, the fix and the build dates it covers.
| Date | Recall | Vehicles affected |
|---|---|---|
| Aug 2025 | Stop-drive takata psanFault: Urgent Safety Warning - Do Not Drive Your Vehicle Affected vehicles were originally allocated to or used for an extended period of time in a region with a climate zone considered to as HIGH RISK. Certain front airbags contain an ageing inflator propellant that may explode when deployed due to long-term exposure to heat and humidity. If the airbag inflator explodes metal fragments may be ejected causing life-threatening or fatal injuries to anyone in the vehicle. Fix: Affected airbags will be be replaced. You can contact Audi's dedicated Takata Stop Drive helpline at 0113 526 9646 (MONDAY to FRIDAY 9:00AM to 5:00PM. | 56 |
| Aug 2024 | Replacing takata driver airbagFault: On imported Audi vehicles previously used in a warm climate zone and fitted with TAKATA driver airbag manufactured within a specific period it is possible that the gas generator housing may cause small metal parts to become dislodged from the housing and potentially injure the driver or a passenger. Fix: As a precautionary safety measure it is necessary to replace the gas generator in the airbag unit on the driver side of the vehicle. | 167 |
| Aug 2023 | On affected vehicles an electrical connector for the power supply for the fuse carrier in the interior of the vehicle may have not been installed correctly.Fault: On affected vehicles an electrical connector for the power supply for the fuse carrier in the interior of the vehicle may have not been installed correctly. Fix: Check the electrical connection and secure if necessary. | 104,162 |
| Oct 2022 | Restraining capacity of the belt system for the front seats may be lower than intended in the event of an accidentFault: The restraining capability of the belt system for the front seats may be lower than intended in the event of an accident.� Fix: As a precautionary safety measure it is necessary to replace both front seat belts. Advice is given�against transporting children on the front passenger seat until the seat belts have been replaced.� | 174 |
| Apr 2022 | The fuse in the high-voltage system may have been manufactured with an insufficient quantity of extinguishing sandFault: The fuse in the high-voltage system (HV system) in vehicles built within a limited period may have been manufactured with an insufficient quantity of extinguishing sand. Fix: Insulation must be fitted above the switching unit for the high-voltage battery. | 3,656 |
| Sep 2021 | The bolted connection on the input rod between the electromechanical brake servo and brake pedal can be come looseFault: The bolted connection of the pull rod between the electromechanical brake servo and brake pedal may come loose resulting in a loss of all service braking ability.� Fix: Vehicles are not to be driven and the bolted connection of the input rod between the electromechanical brake servo and brake pedal must be checked and if necessary retightened. | 11 |
| Aug 2019 | The camshaft adjuster belt pulley may break or the housing bolts may come looseFault: The belt pulley for the camshaft adjuster may break or the bolts for the camshaft adjuster housing may come loose Fix: The camshaft adjuster must be replaced on the affected vehicles | 133 |
| Feb 2019 | Possible discrepancy in the manufacturing process of the centre rear SEAT head restraintFault: The centre rear head restraint may not be to specification. Fix: Check the head restraint and replace if necessary. | 1,573 |
| Nov 2018 | The mounting for the head restraint is not correctly welded to the outer backrest frame for the rear SEATFault: The rear back rest head restraint mounting is not correctly welded. Fix: Check and replace rear back rest frame if required. | 147 |
| Mar 2018 | Starter motor may malfunction and overheatFault: On vehicles with diesel engines and stop/start system the starter motor may be permanently activated because the return spring in the solenoid switch is bent or broken. If the permanent current supply to the starter motor is not noticed overheating of the component with local scorching damage and a vehicle fire is possible. Fix: Recall the vehicles that are likely to be affected and replace the solenoid switch. | 5,208 |
| Feb 2018 | Passenger airbag may not deploy as intendedFault: There is a possibility of a faulty weld on the gas generator. If the airbag is deployed there is a risk that parts could be projected into the cabin with risk of injury to the occupants. Fix: On affected vehicles replace the front passenger air bag module with a correctly manufactured version. | 6 |
| Nov 2017 | Rear hub carriers not manufactured to correct standardFault: The hardening process for the rear wheel bearing housings may not have been correctly performed. In the worst case this could lead to a fractured housing. Should a fractured housing occur there would be abnormal noises bad tyre wear and a theoretical possibility of wheel loss. Fix: Recall the vehicles that are likely to be affected and replace the right and left rear wheel bearing housings. | 30 |
| Jun 2017 | Abs/ESC system may failFault: On vehicles with ABS/ESC the earth connection may be interrupted. This may cause failure of the ABS/ESC system. Fix: On affected vehicles install new software. Where necessary a new ABS/ESC control unit will be fitted. | 38,548 |
| Dec 2011 | Fuel may leakFault: On 2.0l Common Rail engines of a limited production period faulty material can cause leaks on the high pressure pipes during the service life of the vehicle. Fix: Fitting of anti-vibration balance weights must be fitted on the high-pressure pipes. | 1,825 |
| Dec 2009 | Clutch may operate inadvertently with unexpected loss of drive.Fault: In rare cases an incorrect interpretation of the clutch temperature can occur which results in the clutch opening unexpectedly with loss of drive. Fix: Recall affected vehicles and update/reprogramme gearbox control unit. | 1,454 |
| Sep 2006 | Curtain airbag may not inflate in a collisionFault: The gas required to inflate the curtain airbag can escape gradually through a defective welded seam on the gas generator. In this instance the curtain airbag would fail to inflate in a collision. Fix: Recalled vehicles will have the curtain airbag replaced. | 92 |
| Mar 2006 | Flywheel may fail fire may resultFault: The two mass flywheel can become damaged because of a non-optimally designed through-flow restrictor in the clutch pressure pipe. This can lead to a total failure of the flywheel and under unfavourable circumstances to a vehicle fire. Fix: Recall the vehicles that are likely to be affected and establish the manufacturer of the two mass flywheel. Where necessary replace the flywheel and the breather of the clutch pressure pipe. | 25,758 |
| Mar 2005 | Bolts of the tandem fuel pump cover may breakFault: It is advised that on some vehicles fitted with a 3 and 4 cylinder pump injector engine the bolts of the tandem fuel pump cover may break due to a bolt production fault. As a result the pump housing will not be tight and a diesel fuel leak may occur. Fix: Recalled vehicles will have the pump checked for being of a certain manufacture. If found to be within the affected range the pump housing cover bolts will be replaced. | 14,820 |
| Sep 2003 | Shatter cracks may occur on a vacuum pipe to brake servoFault: Shatter cracks may occur on the vacuum pipe to the brake servo near the connections. If a vacuum pipe leaks a lot more force will be necessary to operate the brake pedal. Fix: The fitted vacuum pipes will be checked and replaced if necessary. | 21,335 |
| Oct 2002 | Airbag may not deployFault: On 79 vehicles within the VIN ranges affected (with 3-spoke sports steering wheel) it is possible that in the event of a collision impact above the triggering threshold of the airbags the driver's airbag may not be deployed. Fix: The drivers airbag unit will be replaced on all affected vehicles with 3-spoke sports steering wheel. | 541 |
| Jun 2002 | Anti lock brake control unit concernFault: There is a risk that an electrical fault in the anti lock brake control unit (ABS) can cause overheating of related electrical components. This may lead to fire damage and cause the service brake to revert to a non-anti lock mode of operation. Fix: Recall affected vehicles to check the part number and supplier code of the ABS control unit. Renew the ABS control unit where found necessary. | 99 |
| Jan 1999 | Possible jamming of accelerator mechanismFault: It is possible that part of the throttle actuator mechanism can rub against the bonnet insulation and in a worst-case situation could become jammed. Fix: Recall affected vehicles and fit modified insulation material. | 1,765 |
| Jul 1998 | Rear left and right SEAT belt retractor mounting brackets may be prone to fatigue crackingFault: In isolated cases the securing brackets for the rear left and right seat belt retractors may be prone to fatigue cracking. This means that the seat belts for the outer rear seats may not provide the maximum level of protection under extreme conditions. Fix: Fit reinforcement plates at the belt retractors. | 2,822 |
| Jun 1997 | Front SEAT belt height adjusterFault: The front seat belt height adjuster may not have been manufactured to the correct specification and could endanger the belt wearer in an accident situation. Fix: Affected vehicles are being recalled to dealers for inspection and where required the installation of a new seat belt height adjuster. | 1,097 |
Nothing matches that search on this page.
Vehicles affected is the number DVSA lists for each recall.
How to check a car for recalls
A recall only applies to vehicles built within set dates or VIN ranges, so a recall listed for a model does not mean every car of that model is affected. To check a particular car, enter its registration in our free reg lookup, which shows whether DVSA records an outstanding recall. You can then confirm on GOV.UK's check vehicle recalls service.
A recall count is not a reliability score. Recalls are how manufacturers put faults right, and models sold in large numbers over many years tend to appear more often.
Buying used? A free check does not cover outstanding finance, write-off or stolen records. For those, use our vehicle history check, with data provided by Experian.
Frequently asked questions
How do I check if my A3 has an outstanding recall?
Enter the registration in the free MotifyMe reg lookup. It shows whether DVSA records an outstanding recall for that vehicle. You can then confirm the details on GOV.UK's check vehicle recalls service.
How many recalls has the Audi A3 had?
DVSA's recalls data lists 24 safety recalls covering the Audi A3, the most recent dated 8 August 2025. A recall only applies to vehicles built within set dates or VIN ranges, so check the registration with our free reg lookup to see whether a car has an outstanding recall, then confirm on GOV.UK.
Does a recall mean a car is unreliable?
No. A recall count is not a reliability score. Recalls are how manufacturers put faults right, and models sold in large numbers over many years tend to appear more often.
What should I do if my car is affected by a recall?
Contact a dealer for that make or the manufacturer and quote the recall number. Each recall listing explains the fault and the fix the manufacturer has set out.
Where does this recall data come from?
From DVSA's vehicle recalls data, published under the Open Government Licence v3.0. MotifyMe refreshes these pages from the latest DVSA file each month. These pages were last updated on 22 November 2026.
Recalls are matched to models by the model names in DVSA's file, so a recall listed under a different name may not appear here. Always check the individual vehicle.
Contains public sector information licensed under the Open Government Licence v3.0. Source: DVSA vehicle recalls data.
Last updated 22 November 2026. These pages are refreshed from the latest DVSA file each month.
Send a UK registration to +44 7537 185888 and we reply in the chat with a free vehicle check.
What it can do
- ✓Free vehicle check: send any UK reg for the make, model, MOT and tax status, plus any outstanding safety recall
- ✓Snap a number plate: send a photo and we read the reg for you, then ask you to confirm it
- ✓Free valuation: add the mileage after the reg, for example AB12 CDE 45k. A guide only, not an offer to buy or a guarantee of sale price See terms
- ✓Paid vehicle history check, with data provided by Experian, delivered in the chat
- ✓Free MOT and tax reminders: reply REMIND with a reg (typos are fine)
- ✓Recalls: send RECALLS and a make or model, for example RECALLS Ford Puma
- ✓MOT pass rates: send MOT RATE and a model, for example MOT RATE Ford Fiesta
- ✓How many are left: send HOW MANY and a model no longer sold new, for example HOW MANY Saab 9-3
- ✓Find a vehicle: tell us what you want, for example Ford Fiesta under 8k
- ✓Ask about a vehicle: send its MotifyMe link or reg with your question, or after a search reply ASK, the number and your question, for example ASK 2 is it still available
- ✓Fuel prices: live prices, plus a journey fuel cost such as London to Edinburgh
- ✓Fuel price alerts by email: send FUEL ALERT with your town or postcode, fuel and email address
- ✓Diesel driver? Send FUEL CARD for the Accelerate diesel fuel card, up to 5p a litre
- ✓Reply STOP at any time to opt out
Looking for a Audi A3?
See used Audi A3 cars listed on the MotifyMe® marketplace.
See A3 cars for sale